Script Rf24- Alcance De Arranque- Alcance De Gk... – Updated

if (incoming == expectedPacket) receivedPackets++; expectedPacket++; Serial.print("Good packet #"); Serial.println(receivedPackets); else Serial.println("Out‑of‑order packet – interference!");

void loop() if (radio.available()) int incoming; radio.read(&incoming, sizeof(incoming)); Script RF24- alcance de arranque- alcance de GK...

// Send a simple counter static int payload = 0; payload++; bool success = radio.write(&payload, sizeof(payload)); if (incoming == expectedPacket) receivedPackets++

int receivedPackets = 0; int expectedPacket = 1; Serial.print("Good packet #")

if (success) Serial.print("ACK received. Payload: "); Serial.println(payload); // Here you would update startupRangeOK or GKrange based on distance input // For manual testing: enter distance from serial monitor else Serial.println("Transmission failed – beyond GK range?");

void setup() Serial.begin(9600); radio.begin(); radio.setChannel(100); radio.setPALevel(RF24_PA_MAX); radio.setDataRate(RF24_250KBPS); radio.openReadingPipe(0, address); radio.startListening();

// TX side pseudo‑code void measureRange() for (int power = RF24_PA_MIN; power <= RF24_PA_MAX; power++) radio.setPALevel(power); delay(100); int successCount = 0; for (int i = 0; i < 50; i++) if (radio.write(&testPayload, sizeof(testPayload))) successCount++; delay(10); float successRate = successCount / 50.0; Serial.print("Power level "); Serial.print(power); Serial.print(" success rate: "); Serial.println(successRate); if (successRate >= 0.5) Serial.println("GK range achieved at this power level."); break;